Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
A router has a summary route to network 192.168.32.0/20 installed in its routing table. What range of networks are summarized by this route?
192.168.0.0 – 192.168.32.0/24
192.168.0.0 – 192.168.47.0/24
192.168.32.0 – 192.168.47.0/24
192.168.32.0 – 192.168.48.0/24
192.168.32.0 – 192.168.63.0/24
ccna exploration 2 chapter 6 Exam Question And Answers
A router has a summary route to network 192.168.32.0/20 installed in its routing table. What range of networks are summarized by this route?
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached?
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached? rou...
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
Refer to the exhibit. Why is the state of the serial0/0/0 interface administratively down?
Refer to the exhibit. Why is the state of the serial0/0/0 interface administratively down? An IP address has not been configured on the...
CCNA Dumps - CCNA Final Practice Exam Questions and Answers
Which of the following statements are correct regarding EIGRP EIGRP uses bandwidth and delay as its composite metric by default EIGRP supp...
ccna exploration 1 chapter 5 exam answers
What is a component of a routing table entry? the MAC address of the interface of the router the destination Layer 4 port number the ...
What header address information does a router change in the information it receives from an attached Ethernet interface before information is transmitted out another interface?
only the Layer 2 source address only the Layer 2 destination address only the Layer 3 source address only the Layer 3 destination addres...
A router boots and enters setup mode. What is the reason for this?
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The network that contains the serial link has already been addressed out of a separate range. Each network will be allocated the same number of host addresses. Which network mask will be appropriate to address the remaining networks?
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The n...
Refer to the exhibit. While configuring a network, a technician wired each end of a Category 5e cable as shown. Which two statements are true about this setup? (Choose two.)
The cable is suitable for connecting a switch to a router Ethernet port. The cable is suitable for connecting dissimilar types of devices.