Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which option identifies the primary interface which would be used for initial configuration of a Cisco router?
AUX interface
Ethernet interface
serial interface
console interface
ccna exploration 1 chapter
10
Exam Question And Answers
Which option identifies the primary interface which would be used for initial configuration of a Cisco router?
Newer Post
Older Post
Home
Popular Posts
Which of the following is considered a limitation of RIP v1?
RIP v1 does not send subnet mask information in its updates. RIP v1 is not widely supported by networking hardware vendors. RIP v1 consum...
What type of network is maintained if a server takes no dedicated role in the network?
mainframe client /server peer-to-peer
View Current Logged in User in Linux | Linux whoami Command
View Linux Current User Command : whoami To View Current Logged in User in Linux you can use whoami command in terminal in you...
A router boots and enters setup mode. What is the reason for this?
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
Refer to the exhibit. The network administrator has configured the router with the interface IP addresses shown for the directly connected networks. Pings from the router to hosts on the connected networks or pings between router interfaces are not working. What is the most likely problem?
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a...
The output of the Router# show interfaces serial 0/1 command displays the following: Serial0/1 is up, line protocol is down. What is the most likely cause for the line protocol being down?
Serial0/1 is shutdown. There is no cable connecting the routers. The remote router is using serial 0/0. No clock rate has been set.
Which topology divides the collision domain and provides full media bandwidth to the hosts in the network?
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
What are two characteristics of peer-to-peer networks? (Choose two.)
scalable one way data flow decentralized resources centralized user accounts resource sharing without a dedicated server
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode