Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. Which type of Category 5 cable is used to make an Ethernet connection between Host A and Host B?
coax cable
rollover cable
crossover cable
straight-through cable
ccna exploration 1 chapter 8 Exam Question And Answers
Refer to the exhibit. Which type of Category 5 cable is used to make an Ethernet connection between Host A and Host B?
Newer Post
Older Post
Home
Popular Posts
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
Refer to the exhibit. How will packets destined to the 172.16.0.0 network be forwarded?
Router1 will perform recursive lookup and packet will exit S0/0. Router1 will perform recursive lookup and packet will exit S0/1. Ther...
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
A network administrator has just entered new configurations into Router1. Which command should be executed to save configuration changes to NVRAM?
Router1# copy running-config flash Router1(config)# copy running-config flash Router1# copy running-config startup-config Router1(config...
Which statement describes the correct use of addresses to deliver an e-mail message from HostB to the e-mail service that is running on ServerA?
HostB uses the MAC address of ServerA as the destination. Router B uses a Layer 3 network address to route the packet.
What is the effect of the command copy running-config tftp?
copies the configuration from a remote machine into RAM copies the configuration from a remote machine into NVRAM copies the configuration...
Hosts on two separate subnets cannot communicate. The network administrator suspects a missing route in one of the routing tables. Which three commands can be used to help troubleshoot Layer 3 connectivity issues? (Choose three.)
ping show arp traceroute show ip route show interface show cdp neighbor detail
Which prompt is associated with the privileged exec mode?
R1> R1# R1(config)# R1(config-router)#
Which prompt represents the appropriate mode used for the copy running-config startup-config command ?
Switch-6J> Switch-6J# Switch-6J(config)# Switch-6J(config-if)# Switch-6J(config-line)#