cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. All routers are running RIP version 2. JAX is configured to just advertise the 10.0.0.0/24 network. CHI is configured to advertise the 172.16.0.0/16 network. A network administrator enters the commands shown in the exhibit. What changes will occur in this network?
The JAX router will ignore updates for the 172.16.0.0/16 network due to split horizon issues.
The CHI router will install a route to the 192.168.0.0/16 network in its routing table.
The routing table for CHI will have the 192.168.0.0/16 route but it will have an S next to the route.
The ORL router will apply a 255.255.0.0 subnet mask to all networks in the routing updates it forwards.
Popular Posts
-
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both rout...
-
It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUA...
-
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici...
-
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
-
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol...
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
-
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
-
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ...
-
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta...
