cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. Host A is configured with the correct IP address for the default gateway of the router R1 FastEthernet0/1 interface. How will a packet that is sent from host A to host B be handled by the devices on the network?
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will forward the packet to the directly connected network 10.1.1.0/24.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not have a default route to network 10.1.1.0/24.
R1 will forward the packet to its default gateway, the next hop router R2. R2 will drop the packet because it does not have a route that is learned by a routing protocol to network 10.1.1.0/24.
Popular Posts
-
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both rout...
-
It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUA...
-
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici...
-
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
-
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
-
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ...
-
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta...
-
Refer to the exhibit. All routers are properly configured with default configurations and are running the OSPF routing protocol. The netwo...
-
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol...
